Info request

1/4”- 4” heavy pattern
hot forged brass gate valve

Technical Data
  • Suitable for water-works, domestic and agricultural installations
  • Heavy configuration suitable to most difficult applications
  • Hot forged sand blasted unplated brass body
  • Low pressure drop
  • High performance EPDM stem seal
  • ISO 228 parallel female by female threads
  • Strong red coated steel hand-wheel
  • Zinc plated steel top nut
  • WARNING: do not exceed reasonable temperature and/or electrical load
Working pressure & temperature
  • 20 bar (300 PSI) non-shock cold working pressure
  • -10°C to + 80°C (+15°F to +175°F)
  • WARNING: freezing of the fluid in the installation may severely damage the valve
PED directive
  • The product described in this document meets the requirements of PED Directive 2014/68/UE and according to art.4 par.3, it does not require CE marking; it cannot be used with dangerous gases in sizes larger than 25mm; it cannot be used with non-dangerous gases in sizes larger than 50mm
Approved by or in compliance with
  • GOST-R (Russia)

NOTE: approvals apply to specific configurations/sizes only

Part descriptionQ.tyMaterial
2Gate1CB 754S
4Body cap sealing1Guarnital Fibre
6Stem ring1CW614N
7Packing gland seal1EPDM
8Packing gland1CW614N
9Packing gland nut1CW614N
10Red round handle1Steel
11Handle nut1Steel
Ask for additional information on the whole range of RuB products and consult with your supplier for special applications.
XCE111 - 4266