s.190M with built-in filter and magnet

Info request

3/4″ – 2″
hot forged brass ball valve

This ball valve with built-in vertical filter allows a large flow rate with a low pressure drop and supports a maximum pressure of 30 bar (PN).
This innovative product avoids the installation of two ball valves, before and after the filter. Quick and easy assembly, maintenance and cleaning.

Technical Data
Quality

• Substitutes 3 different components (2 ball valves and one filter)
• Reduces leakage risks due to lower sealing points
• Cost saving due to reduced number of components
• Time saving at installation and maintenance
• Built-in vertical filter with cartridge structure in 1.4301 / AISI304 + Nylon
(filtration degree: 500 microns / 35 mesh).
• Final test conforming with UNI EN 12266-1 points A3 / A4
(for 1 ½” and 2” sizes: acc. to directive 2014/68/UE)
• No metal-to-metal moving parts
• Handle clearly shows ball position
• Chrome plated brass ball for longer life
• Handle stop on body to avoid stress at stem

Body

• Hot forged sand blasted, external nickel plated brass body and cap sealed with Loctite® or equivalent thread sealant
• Finest brass according to EN 12165 and EN 12164 specifications
• Bottom plug for an easy filter maintenance

Stem

• Blowout-proof unplated brass stem
• Two O-rings at the stem (FKM + NBR) for maximum safety

Sealing

• Pure PTFE seats

Threads

• ISO 228/1 parallel female by female threads

Flow

•Nominal port

Handle

• Zinc plated steel handle with plastic cover
WARNING: do not exceed reasonable temperature and/or electrical load

Working pressure & temperature

• 30 bar (450 PSI) non-shock cold working pressure for sizes 3/4” to 1”,
20 bar (290 PSI) for sizes 1 ¼” to 2”
• -20°C to +100°C (-4°F to +212°F)
• Valve conforming with directive 2014/68/EU
WARNING: freezing of the fluid in the installation may severely damage the valve

Options

• T-handle for ½” to 1” sizes

PED directive

• According to 2014/68/UE, 1 ¼” and superior sizes cannot be used with dangerous fluids

Approved by or in compliance with

• Water Regulations Advisory Scheme (United Kingdom)

 

NOTE: approvals apply to specific configurations/sizes only.

Part descriptionQ.tyMaterial
1Nickel plated body 1CW617N
2End connection1CW617N
3Seals2PTFE
4Stem 1CW614N
5Chrome plated ball1CW617N
6O-Ring1NBR
7O-Ring1FKM
8Filter 11.4301 / AISI304 + Nylon
9Filter11.4301 / AISI304 + Nylon
10Flat seal1NBR
11Plug1CW614N
12Handle1Zinc plated steel, plastic cover
13Nut1Zinc plated steel
14Screw1Stainles steel
15Magnet1Neodymium (12,000gauss) NdFeB

Suitable for dangerous fluids, in compliance with DIRECTIVE 2014/68/EU
Group 1 fluids

 

 

 

Pressure - temperature chart
Pressure drop chart

Ask for additional information on the whole range of RuB products and consult with your supplier for special applications.
XCE190M - 4266